Printer Resetter Service Manual

Deskripsi

Amazing print speed, superb quality and longer lasting prints
Enjoy speed high quality and affordable printing with the Epson Stylus™ T20E

Assured Quality with Epson DURABrite™ Ultra Ink
* Ideal all-purpose ink for everyday printing
* Smudge, water and fade-resistant qualities ensures prints stay vibrant for many years to come

Epson INKdividual™ Cartridges for Maximum Value
* Replace only the cartridge that runs out
* Affordable INKdividual™ cartridges
* Reduce ink wastage and maximise savings

Excellent Print Speed to Boost Productivity
* Maximise time efficiency and productivity
* Achieve more in less time with excellent print speed of up to 26ppm

High Resolution for Superior Print Quality
Assured high quality printouts at up to 5760 dpi

Photo Perfection with Epson Creative Suite
* One-stop photo software solution
* Achieve photo lab quality prints in 3 simple steps with Epson Easy Photo Print
* Epson PhotoEnhance automatically adjusts images to give you amazing
true-to-life colour photos

How to Reset Epson Stylus T13

1. The first step of course Epson T13 printer driver must be installed.

2. Download software resetter Epson T13 first. Epson Resetter Software named T13, you can download at the link below

3. Date computers do not need to be changed as previously resetter.

4. CAUTION! Turn off your Antivirus, because resetter T13 is detected as virus by antivirus software.

5. Run the program resetter Epson T13 with a double click on the "AdjProg.exe".

6. Then follow the following picture:







Check: used to counter check the maximum 7800 points, you can see it in the main pad counter. If more or close to 7800 points means the printer needs to be reset"

Initialization: used to reset or clear the counter back to the printer"

6. When finished turn the printer off then on again. The printer will flame with a full green light. Epson Stylus T13 printer means that blink had been ready for use again.

Download File :  T13.zip

Pass : Klik

You will need a T10 Torx (star) screwdriver, available from Home Depot, Sears and the like.

1. Remove rear door
2. Remove 2 screws from the back panel
3. Lift rear panel and wiggle - May break on one side
4. Unplug 3 x flat cables and 1 x molex. Unscrew flat cable clamp
5. Pull out left side cover so that scanner can be lifted vertical and removed
6. Remove the encoder strip releasing at the non-spring end (right side when viewed from the front)
7. Take your time with this, it is easy to rip the hole
8. Release carriage belt from motor and pulley
9. Remove 3 screws from the carriage shaft/bar and slide the bar out. DO NOT turn the printer upside down after doing this.
The carriage should now be free but still attached by the 2 flat cables
10. Unplug the 2 flat cables