Wednesday, March 6, 2013
Browse »
home»
reset
»
fix or repair HP 7310 Printer
You will need a T10 Torx (star) screwdriver, available from Home Depot, Sears and the like.
1. Remove rear door
2. Remove 2 screws from the back panel
3. Lift rear panel and wiggle - May break on one side
4. Unplug 3 x flat cables and 1 x molex. Unscrew flat cable clamp
5. Pull out left side cover so that scanner can be lifted vertical and removed
6. Remove the encoder strip releasing at the non-spring end (right side when viewed from the front)
7. Take your time with this, it is easy to rip the hole
8. Release carriage belt from motor and pulley
9. Remove 3 screws from the carriage shaft/bar and slide the bar out. DO NOT turn the printer upside down after doing this.
The carriage should now be free but still attached by the 2 flat cables
10. Unplug the 2 flat cables
fix or repair HP 7310 Printer
1. Remove rear door
2. Remove 2 screws from the back panel
3. Lift rear panel and wiggle - May break on one side
4. Unplug 3 x flat cables and 1 x molex. Unscrew flat cable clamp
5. Pull out left side cover so that scanner can be lifted vertical and removed
6. Remove the encoder strip releasing at the non-spring end (right side when viewed from the front)
7. Take your time with this, it is easy to rip the hole
8. Release carriage belt from motor and pulley
9. Remove 3 screws from the carriage shaft/bar and slide the bar out. DO NOT turn the printer upside down after doing this.
The carriage should now be free but still attached by the 2 flat cables
10. Unplug the 2 flat cables
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment